The DW716 12" Double-Bevel Compound Miter Saw has a 15 Amp motor for extended power and durability. Features stainless steel miter detent plate and cam miter lock that provide repeatable accuracy and durability with easy adjustments. Tall sliding fences support 6-5/8" of nested crown and 6-1/2" of base molding vertically. Lightweight design, head lock-down pin, and built-in carry handle for portability.

Specifications:

• Wood Only

• Cut depth: 2x8” cut at 90°, 2x6” cut at 45°

• 4,500 RPM

• 15 Amps

• Blade Size: 12”

Use & Safety Checklist:

1. Always wear safety glasses and hearing protection when operating

2. Avoid loose clothing, jewelry or anything that could get caught in the machine

3. Do not cut metal on this saw

4. Adjust angle of blade as needed. If cutting at an angle, remove tall aluminum fence prior to cutting. Ensure swing arm is clear before cutting. Only make adjustments when power is off and machine is not moving. Never touch the blade when saw is plugged in

5. Line up your cut and clamp down your material. Verify it’s secure and against the fence. Verify you can hold your piece without putting your hands near the blade. Only cut one piece at a time. Do not cut pieces smaller than 6” long. Do not cut through wood knots, splits, or other defects

6. When ready, grasp handle firmly, pull trigger, and allow motor to reach full speed before cutting. Never start with blade touching the material

7. Cut slowly and smoothly, keeping your hands away from the blade at all times. Keep your body to the side of the blade, and do not overreach when cutting. Maintain proper balance

8. Wait for the saw to stop moving completely and remove hand from trigger before removing material